Products

Truss History

Question: 

How long has the truss industry been around and where did it start?

Substituting Fire Rated Wood Truss Assemblies For Light Gauge Steel

Question: 

We recently received bids on a school project, which referenced UL P523. This assembly used light-gauge steel trusses. We noted on the drawing that we could accept an alternate design using wood trusses in lieu of light-gauge steel framing, if the alternate design could meet the fire ratings.

Truss Span Tables And Details

Question: 

Are there any typical wood truss span tables for roofs and floors available? Standard framing details for use in preliminary design?

Truss Failure And Repair

Question: 

I am a professional engineer looking for information concerning the failure of metal plate connected wood trusses and methods of repair. I am looking for this information with regard to developing recommendations for the repair of truss systems in the floor structures of two-story multi-family dwellings. I see frequent failure of truss systems of this type in both in bending and due to catastrophic failure at the gussets.

Gable End Bracing

Question: 

Manufactured gable ends are actually frames even though they are often referred to as trusses. The webs are “studs” oriented vertically and usually spaced at 12, 16 or 24 in. O.C. The gable end frame is designed to transfer vertical loads from the roof to the continuous bearing wall below. Another way gable end frames are different from trusses placed in the interior of the structure is that frames experience perpendicular wind loads. The sheathed frame transfers the wind loads to the roof and ceiling diaphragms and vice versa.

Allowable Quality Tolerances

Question: 

What tolerances are allowed for metal plate connectors in wood trusses? How do you take into account the possible presence of splits, waves and knots?

Sloping Floors

Question: 

In our one-year-old home, as you approach the hallway, the floor slopes downward. Our home inspector said that this was most likely due to the fact that the walls were resting on the floor as opposed to being load-bearing walls. What has been your experience with sloping floors in a new home? The floors are very flat elsewhere until the walls start. Do you think this sloping could turn into a structural problem eventually?

Truss Uplift

Question: 

I want to get a good definition on what causes “truss lift,” when the trusses will actually raise off the top plates of interior walls (even when nailed), causing the drywall to crack. Is it from drastically different temperatures in the attic and living area?

In Floor Radiant Heat

Question: 

Do you have any information on the use of in-floor radiant heat with 4x2 open-web floor trusses? Are there any adverse effects to the lumber as a result of moisture build up?

Penetration Of Fire Walls

Question: 

Can a roof truss penetrate a one-hr. tenant separation wall without having a one-hr. rated ceiling? The building official insists that the 2x4 chords are combustible and nullify the integrity of the one-hr. rated partition that is constructed in an attic above an 8 in. C.M.U. bearing wall. The partition consists of gypsum board attached to 2 x 4 stud framing. The building official insists that a ledger must be attached through the gypsum board to support the trusses each side of the wall. This is almost saying that any rated assembly must have bearing only on other rated assemblies.