Business Logistics

Determining Necessary Truss Height

Question: 

How high would a truss have to be to span 33 feet 9 inches?

Attic Ventilation

Question: 

I need to put a new roof on my single-family dwelling. The house originally had gable and soffit/eave vents. The roofing contractor suggested that we install a ridge vent when new roof is installed. Should the existing gable vents be blocked off or does it not matter? I have read some debates about whether or not the combination of gable and ridge vents substantially reduces the effect of the soffit vents by having the intake now at the gable vents and exhaust at the ridge. Would this type of ventilation affect the truss warranty?

Unsecured Spacers

Question: 

During a home inspection, the inspector stated that the spacers were not secured at the attic trusses. What did the home inspector mean by this?

Jobsite Inspections

Question: 

Consider this statement from a set of construction contract documents: “The Truss Manufacturer is responsible for inspecting the truss installation, bracing, anchorage and bearings and preparing a letter of verification stating that trusses are installed and braced properly.” At first glance, it may seem that the truss manufacturer is the most logical party to perform such an inspection. They are the truss experts, are they not?

The Need To Use Both Floor And Roof Trusses

Question: 

While building a new 2-story home, I found the need to use floor trusses between the 1st and 2nd floors. Is it true that I must also use roof trusses?

Installation Guidelines

Question: 

What are the requirements on the permanent bracing of bottom chords? Can gypsum board diaphragms be used?

Responsibility Of Snow Drift Load Calculations

Question: 

Is the truss designer or the building designer responsible for calculating snow drift loads on a roof system?

Definition Of P E

Question: 

What does “P.E.” stand for in building construction?

Allowable Variances In Trusses

Question: 

My framers are always complaining that the “trusses are bad.” I am looking for tolerance information that not only addresses the allowable variance in length and height, but also allowable variation in the top chord with regard to straightness (i.e. how straight should a pull string line from the top and bottom of top chord be?). Also, if trusses are set on a perfectly level wall, what variation is allowed from truss to truss (i.e. if I put a 10 ft. straight edge perpendicular to the trusses, how much can they vary in height, not just at peak or bottom but all along the top chord)?

Storage Loading

Question: 

How much weight can a wood truss hold, when it’s made with 2x4 material and spans 36 ft. with a 4/12 pitch. I would like to hang things from the ceiling and am wondering if it is safe. I live in an area where there are heavy snowstorms. Also, how much exposure to the weather can a truss handle before there is a problem?